Thanks Bob.
At this time I am checking an item that calls for material diams up to about 3", but I'll try some suppliers directly.
Thor
-----Original Message-----Thor-
From: Robert Kazanjy [mailto:rkazanjy@gmail.com]
Sent: June 8, 2007 10:06 PM
To: seaint@seaint.org
Subject: Re: AISI 12L14 Steel
I'm sure there are properties avaible for larger diameters because larger diameter material is available to purchase.
McMaster has 12L14 per ASTM A108 up to 4"
http://www.pmtsco.com/12L14CD.HTM
has cold drawn 12L14 up to 5 1/2" diameter
so if you were to buy material from either one of these suppliers I'm sure they could provide chemical & physical certs for the material
I could not find an online source for the mechanical properties for 12L14 in sizes larger than 38mm (1.5")
Unless someone else has them I think you're looking at trip to the library or offering to purchase the info from a material supplier or producer.
cheers
Bob
On 6/8/07, Thor Tandy <vicpeng@telus.net> wrote:AISI 12L14 Steel
I have data for drawn diams 19 to 38mm. Does any one know if there is are available properties for greater diams?
Thanks
Thor A. Tandy P.Eng, MIStructE, Struct Eng
Victoria, BC
vicpeng@telus.net