Check out www.mcmaster.com
page 3156
the washers are for standard I-beams 16% slope (1:6)
they're available in iron for about 40 to 50 cents (small to medium sized bolts) up to about $1 each in large sizes.
If these don't fit the bill .........a machine / heavy sheet metal shop could shear, punch & shear then up out of channel flange for you....
punching & shearing would be the cheapest means of making them custom but they'd be pretty coarse, not pretty
cheers
Bob
On 5/16/07, Gary L. Hodgson and Assoc. <ghodgson@bellnet.ca> wrote:
David,
As far as I know, bevelled washers are available but expensive and hard
to find. i always recommend to fabricators to cut up some flanges from
left over channels and use them to make washers=easy and relatively
cheap. Another alternative is, if you have a good burning machine, is to
cut flat bar in half on a taper to get your bevelled material and then
drill. Sometimes it takes a bit of additional grinding. Shops do this
all the time to make wedges for fitting steel.
Gary
davidfinley@bizsea.rr.com wrote:
> A retrofit requires adding top & bottom plates to "box in" 2 existing MC channels. I know the flange slope of MC channels is different than "standard" C channels. Are beveled washers for MC channels readily available? Are the same washers used for both types of channels?
>
> David Finley
>
> ******* ****** ******* ******** ******* ******* ******* ***
> * Read list FAQ at: http://www.seaint.org/list_FAQ.asp
> *
> * This email was sent to you via Structural Engineers
> * Association of Southern California (SEAOSC) server. To
> * subscribe (no fee) or UnSubscribe, please go to:
> *
> * http://www.seaint.org/sealist1.asp
> *
> * Questions to seaint-ad@seaint.org. Remember, any email you
> * send to the list is public domain and may be re-posted
> * without your permission. Make sure you visit our web
> * site at: http://www.seaint.org
> ******* ****** ****** ****** ******* ****** ****** ********
>
>
******* ****** ******* ******** ******* ******* ******* ***
* Read list FAQ at: http://www.seaint.org/list_FAQ.asp
*
* This email was sent to you via Structural Engineers
* Association of Southern California (SEAOSC) server. To
* subscribe (no fee) or UnSubscribe, please go to:
*
* http://www.seaint.org/sealist1.asp
*
* Questions to seaint-ad@seaint.org. Remember, any email you
* send to the list is public domain and may be re-posted
* without your permission. Make sure you visit our web
* site at: http://www.seaint.org
******* ****** ****** ****** ******* ****** ****** ********