----- Original Message -----From: Jim LutzSent: Wednesday, July 18, 2007 11:57 AMSubject: Interior Wall LoadingThe 5 psf minimum lateral load on interior walls (2006 IBC 1607.13) is an interesting subject. This minimum load is in the live load section of the code, so I would expect it should be treated as an "L" load in the load combination equations. Another possible load, however, is internal pressure due to wind loading. If you run through the numbers in ASCE 7-05 6.5.11, you will find that the internal pressure qi x GPpi can easily be 5 psf or more. The wind provisions only require this internal pressure to be applied to exterior elements, but when you think about it, what happens when an exterior door blows open or a window blows out or is left open during a windstorm? You could easily have a situation (imagine a typical elementary school) where a room becomes pressurized relative to a corridor. IBC provision 1607.13 requires not only a 5 psf minimum for interior wall loading, but design for "loads to which they are subjected." Anybody out there ever bother to check interior walls for wind? I don't think 5 psf is too conservative to hedge your bets.
720 3rd Avenue, Suite 1200
Seattle, WA 98104-1820
206 505 3400 Ext 126
206 505 3406 (Fax)
Wednesday, July 18, 2007
Re: Interior Wall Loading
We were just having this conversation yesterday for interior steel stud partition design loading. If "typically sized" windows and/or doors blow out the area of the incoming pressure would get spread out over a much larger interior wall/ceiling/floor surface..thus the internal pressure of 5 psf is reasonable. If you are dealing with a partition wall directly behind a wall of continuous overhead doors or other similar building with very large openings then I think it would be reasonable to increase the loading to account for increased pressures.
Dave Handy, P.Eng.