Re: Deformed wire anchor (DWA) design

Yes.  That's what Nelson recommends for their anchors.  Check to see what fy they have.  Also I recommend NOT end welding, but weld along the axis, if possible.


>>> ??? <yhnam@kopec.co.kr> 9/19/2007 12:57 PM >>>

Dear All:

 

I am going to design embedded plate using deformed wire anchor (DWA).

However, ACI 318-05 App. D did not mention any anchor design for DWA.

 

Therefore, I would like to design DWA using Chapter 12 of ACI code "Development of reinforcement".

Is the above assumption reasonable and do I need other concrete cone failure check for shear loading?

Thanks in advance.

 

Yoon-Ho Nam

 

 

 

 

---

 

�� ����: �߿�d���� ��� d���� ���ԵǾ� ��; �� ��8�Ƿ� �� d���| ��ü��8�γ� �κ� ��8�� ���� ��, ����, �����ϰų� ����� �� ��4ϴ�. ���� ���ϰ� d���� ������� �ƴ϶�� �� ����; �߽��ο��� ��� ȸ���Ͻ� �Ŀ� ���|�Ͽ� �ֽñ� �ٶ�ϴ�.

�� ���Ͽ� ���Եǰų� �Բ� ��۵� �����͸| ����Կ� ��� �ͻ� ���ý��ۿ� �߻��� �� �ִ� ��� ���� ����, �Ѽտ� ���Ͽ� ȸ��� å������ �ʽ4ϴ�.

 

******Internet Email Confidentiality Footer******

Privileged/Confidential Information may be contained in this message. Any unauthorized dissemination, distribution, copying or use of this message in whole or in part is strictly prohibited. If you are not the intended recipient, please notify the sender immediately by replying to this message and then delete it from your system.

KOPEC does not accept any responsibility for any loss, disruption or damage to your data or computer system that may occur while using data contained in, or transmitted with, this e-mail.

 

---