Bill,
This table may (and not necessarily will) work only for the "standard" oversize.
According to Section "Washer Requirements" (page 14-10), the washer "thickness must be suitable for the forces transferred." In my understanding, that thickness was the original question.
V. Steve Gordin, SE
Irvine CA
Irvine CA
----- Original Message -----From: William.Sherman@CH2M.comSent: Thursday, June 25, 2009 14:02Subject: RE: Anchor rod washersTable 14-2 in AISC Manual, 13th Edition. Base plate holes are oversized, washer holes are standard size.Bill ShermanCH2M HILL / DEN720-286-2792
I am trying to track down the recommended washer plate thickness for anchor rods. Typically the holes are oversized and I am trying to find the thickness for the washers. i assume it is some percentage of the rod diameter. Can anyone direct me to where i can this info?
From: Drew Morris [mailto:dmorris@bbfm.com]
Sent: Thursday, June 25, 2009 2:25 PM
To: SEAINT
Subject: Anchor rod washers